Category: Antennas – General Principles

Part 1 – A simple transmitter, transmission line, and an “End-Fed” antenna WITHOUT a formal “Counterpoise” – We will see why common-mode current must ALWAYS flow on the coax shield.

End-Fed Antennas have been around since the good ‘ol days and were once most popular.  Yet for some reason, much discord still exists regarding the “counterpoise” – what its behavior is, or if one is even needed.  Not all that surprising since the term “counterpoise” doesn’t seem to have a firm definition.  Hopefully, we can figure out what’s going on despite the semantics, and deal only with easy to understand basic principles.

Principles like this from basic physics:

“…charge conservation is the principle that electric charge can neither be created nor destroyed.”*

Continue reading Current Flow Fundamentals for an “End-Fed” Antenna – part 1

14,928 total views, 10 views today

Please follow and like us:

Part 3 – We place various devices at the feedpoint of an “End-Fed” antenna without a formal “Counterpoise” – We will see why the SAME common-mode current must ALWAYS flow on the coax shield just as in Part 1.

The typical “end-fed” generally has an impedance greatly different from 50 ohms, so it is rarely fed directly with coax, as losses on the transmission line will be undesirably high for lengths of coax greater than a few 10’s of meters.

Note the high loss on several bands when a 42 ft “end-fed” is directly fed with 50 ft of RG8x coax (yellow bars)* ===>

Continue reading Current Flow Fundamentals for an “End-Fed” Antenna – part 3

6,280 total views, no views today

Please follow and like us:

Part 2 – A 40 Meter EFHW with a “Radiator” wire and various length “Coax-as-Counterpoise” wires is analyzed – We will see that the common-mode current is almost always LARGER on the coax shield some distance away from the feedpoint, which is why the “counterpoise” radiates and is called “the other half of the antenna”.

It is sometimes said that common mode current flow on the coax shield of an “End-Fed” antenna system is everywhere low,  simply because the feedpoint current is relatively low.  This is claimed even for systems with no “counterpoise”.  In this article we will see that this is not true.

“…charge conservation is the principle that electric charge can neither be created nor destroyed.”*

As shown in Part 1, from this perfectly reasonable principle we now know that there are NO 1-Terminal RF power sources!

2 Terminals – YES!            1 Terminal – NO!

Continue reading Current Flow Fundamentals for an “End-Fed” Antenna – part 2

6,859 total views, 4 views today

Please follow and like us: